In the event of an uncontrolled fall of the rig or in extreme situations such as a skidding fall, the rig first hits the protector. During this contact, the energy generated is dissipated by deformation of the power joint (elastomer material). This allows the entire board to be better protected.
Prepared for mounting with 1-pin and 2-pin mast bases.
The deck protection pad (silicone rubber) protects the sensitive deck surface between WBP and surfboard.
Included in the standard set.
An optimised geometric design and simulation of the design structure saved material, reduced weight and at the same time achieved the required strength and function.
All common mast bases up to 122mm diameter can be mounted through the generously dimensioned mounting surface of the protector.
Compared to other solutions, the mass of the protector is close to the centre of gravity of the board and therefore has hardly any impact on balance and performance.
An eye-catcher thanks to a harmoniously chosen shape combined with an unusual choice of colours give your board that certain something.
With the mast foot, the friction disc is replaced by the protector and mounted as usual.
Freestyle manoeuvres are not impaired by geometrically caused interference contours.
Adjustment range of the mast track is still maintained.
The waterstart is facilitated by the shape of the protector and the resulting lift-up effect (lifting of the sail towards the launch position).
Handling in the water is hardly affected by the flowing shape.
Your windsurfing board consists of high-quality, expensive materials that need to be protected so that you can enjoy your board for a long time - that's why we developed surfbent WBP. Surfbent WBP can protect your board from pole damage, which requires expensive and time-consuming repairs.
